Solutions Products Support About Us Find a Distributor Contact Us
Solutions Products Support About Us
Solutions Products Support
honing.svg
S
honing
Number of products: 2
Application: honing
Metal: titanium [S]

TRIM™ C385

High-lubricity Honing Synthetic

TRIM C385 is a state-of-the-art synthetic coolant which provides excellent cooling and chip removal, good tramp oil rejection and machine cleanliness. C385 meets the need of the modern job shop for a single premium synthetic coolant for honing and virtually all machining operations.

  • Very low foam and mist
  • Great for form grinding, honing, boring, rolling, etc
  • Exceptional sump life and very good tramp oil rejection
  • Extremely low carry-off for very low total operating costs
  • Very low initial odor which usually disappears after 1-2 days
  • Compatible with dirty or grey cast iron cutting, grinding, and honing
  • Keeps your machines clean while leaving a soft, fluid film that protects the bare metal parts
  • The residual film is easily resoluble in the coolant working solution to facilitate easy machine cleaning and to minimize the buildup of sticky residues that can hold machine-destroying chips

TRIM™ E950

High Performance Machining Emulsion

TRIM E950 is a proprietary blend of new vegetable-based technology and premium traditional lubricity additives to yield a very high performance, low management metal removal fluid. This premium emulsion product is operator friendly because of its mild contact nature and low chemical initial-charge odour. TRIM E950 is robust enough to deliver extended useful life and avoid rancid odours normally associated with traditional emulsions. The unparalleled lubricity delivers exceptional surface finish and tool life on difficult to machine aluminium alloys, inconel, titanium, stainless and high tensile strength steels.

  • Delivers unparalleled lubricity
  • Very long sump life and low carry-off rates result in low operating cost
  • Low foam even in soft water areas
  • Hard water tolerant
  • Non-chlorinated and non-sulphurised extreme pressure (EP) additives control built-up edge (BUE) in tough operations on aerospace materials
  • Fine emulsion ensures fast wetting to get the fluid to the point of cut and fully coat the work piece and chips for superior tool life and corrosion prevention
  • Compatible with all materials excluding magnesium
  • Easily recycled or disposed of without special handling or equipment
  • Will run effectively for long periods without the need for costly additives